NanoTabs                                                      
** 5/1/25   Ubiquiti  
      NanoTabs  
                                                         
   
  UniF Network   Network     Advanced     Wireless     Main   Tools:
  NotesUniFi Network Align antenna
  AP Network Role       Advanced Wireless Settings     Basic Wireless Settings       Status         Site Survey
  Nanostation Network Mode Router RTS Threshold 2346    X Off Wireless Mode Station AP MAC Speed Test
  NanoTabs Disable Network None Distance 0.4 miles (.6 km)   X Auto Adjust WDS (Transparent Bridge Mode)  _ Enable Signal Strength
  ERL3notes Aggregation 32  Frames  50000 Bytes  X Enable SSID Dick's House SSID Select TX/RX Rate
  ERL3setup Configuration Mode       Multicast Data  X Allow Lock to AP blank
  YouTube Configuration Mode Simple Installer EIRP Conrol   _ Enable Country Code United States
  FileLocations Extra Reporting  X Enable IEEE 802.11 Mode B/G/N mixed SSID The AP that the Nano is connected to.
  Glossary WAN Network Settings       Sensitivity Threshold, dBm -96   X Off Channel Width Auto 20/40 MHz ACK/Distance Distance to that AP.
  SignalStrength WAN Interface WLAN0 Frequency Scan List, MHz  _ Enable
    IP Address X DHCP _ Static _ PPPoE Calculate EIRP Limit  X  Enable
    DHCP Fallback IP 192.168.10.1 Advanced Ethernet Settings     Antenna Built in (2x2)  -8 dBi Monitor          
    DHCP Fallback Netmask 255.255.255.0 Lan0 Speed 10/100  Auto Output Power 23 dBm    (set to Max Power)              Throughput   AP Information   Interfaces   DHCP Client   
    MTU 1500 Data Rate Module Default ARP Table   Routers   Port Forward   DHCP Leases   Log 
    NAT  X  Enable Max TX Rate, Mbps MCS 15 - 130/144.4 [270/300]   X Auto
    NAT Protocol  X SIP  X PPTP  X FTP  X RTSP Signal LED Thresholds       DHCP Client Information  
    Block management access  X  Enable Wireless Security       WLAN0  
    DMZ  _  Enable Thresholds, dBm LED1  LED2  LED3  LED4 Dick's House Wifi info Info that the Wifi AP that you connected
    Auto IP Aliasing  _  Enable default  -94     -80      -73     -65 Security WPA2-AES   to provided to your Nano WLAN.
    MAC Address Cloning  _  Enable ie   optional  -90     -80      -70     -67 WPA Authentication PSK
    WPA Preshared Key   psswd  X Show Renew Release Refresh
    LAN Network Settings       I used  -90      -80      -73     -67
    LAN Interface LAN0 Change  The info tells us that the WIFI AP has assigned all the necessary numbers
    IP Address 192.168.10.1 Change      to the Nano for connecting to the internet.  Numbers will vary with AP's.
    Netmask 255.255.255.0 If blank, internet access will not work.  Some AP's can take upto 30 sec's
    MTU 1500     to assign numbers and sometimes you have to click "Renew" for success.
    DHCP Server  _ Disabled  X Enabled  _ Relay
    Range Start 192.168.10.100
    Range End 192.168.10.200
    Netmask 255.255.255.0
    Lease Time 600
    DNS Proxy  X  Enable
    UPnP  _  Enable
   
    DHCP Address Reservation      
   
    Port Forward      
   
    Multicast Routing Settings      
   
   
    Change